Danfoss Heating
5
GB
3. Transmission Test
Activate Install mode on the Remote Controller - fi g. 1
• When the batteries have been connected, follow the installation
guide, beginning with the selection of language.
• After the installation process, set time and date. Use the up/down
selector and the left/right selector to carry out the settings.
Confi rm settings with OK activated by soft key 1 ( ).
• The installation process is concluded with the opportunity to
name the rooms in which the Room Thermostats are placed. This
makes access to and handling of the system very easy.
• In the
Name rooms
menu, activate the
change
menu with
soft key 2 ( ) to change the default room names from e.g. MC1
Output 1.2 (Master Controller 1, output 1 and 2) to living room,
and confi rm with OK. You can also use the
spell
…. menu to create
other names.
• When the installation is fi nished the start up screen will be shown
in the display with the actual time and date on the top. The screen
also shows the actual temperature in the room from the top of the
rooms list.
See chapter 5.3 to select another room for the start up screen.
Note: Keeping a button activated during settings will make the value
change faster.
Initiate a transmission test on the Remote Controller
From the start-up screen, activate the:
Link test
menu to activate a test of the wireless transmission
between the Master Controller and the Remote Controller. The status
of the link test will be displayed right after the test has been carried
through.
If the link test is not successful:
• Try to relocate the Remote Controller in the room.
• Or install a Repeater Unit (CF-RU, see fi g. 5 c), and place it between
the Master Controller and the Remote Controller.
Note: The link test may take a few minutes depending on the size of
the system
.
