Danfoss AHF 005, Operating Instructions Manual

Page: 11 / 30

3 Specifications
3.1.1 General technical data
AHF 0xx AHF 0xx AHF 0xx AHF 0xx AHF 0xx
Nominal supply
voltage U
L,N
[V] 380 ≤ U
L,N
≤ 415 380 ≤ U
L,N
≤ 415 440 ≤ U
L,N
≤ 480 500 V 690 V
Tolerance of the ac-
tual supply voltage
U
L
[V] 342
≤
U
L
≤ 456
342
≤
U
L
≤ 456
396
≤
U
L
≤ 528
450
≤
U
L
≤ 550
621
≤
U
L
≤ 759
Supply frequency f
L,N
[Hz] 50 ± 5 % 60 ± 5 % 60 ± 5 % 50 ± 5 % 50 ± 5 %
Overload capability 1,6 for 60s
Efficiency η [%] ~ 98.8 %
THiD [%] AHF 005 < 5%
AHF 010 < 10%
cos φ of I
L
0.5 cap
0.8 cap
0.85 cap
0.99 cap
1.00
at 25% I
AHF,N
at 50% I
AHF,N
at 75% I
AHF,N
at 100% I
AHF,N
at 150% I
AHF,N
Power derating [%/C]
[%/m]
40°C < Ta < 55°C => 3%/C
1000m altitude above sea level.< h ≤ 4000m altitude above sea level => 5%/1000m
NB!
The reduction of the low harmonic current emission to the rated THiD implies, that the THvD of the non-influenced mains voltage is
lower than 2% and the ratio of short circuit power to installed load (R
SCE
) is at least 66. Under these conditions the THiD of the mains
current of the frequency converter is reduced to 10% or 5% (typical values at nominal load). If these conditions are not or only partially
fulfilled, a significant reduction of the harmonic components can still be achieved, but the rated THiD values may not be achieved.
3.1.2 Environmental data
Permissible
temperature range*
During transport of the unit:
During storage of the unit:
During operation of the unit:
-25°C...+70°C (to VDE 0160)
-25°C...+55°C (to VDE 0160)
5°C...+40°C without power derating
5°C...+55°C with power derating
Humidity class* Humidity class F without condensation ( 5% - 85% relative humidity)
Installation height h* H
≤
1000 m altitude above sea level
1000 m altitude above sea level< h ≤ 4000 m altitude
above sea level
without power derating
with power derating
Degree of pollution VDE 0110 Part 2 degree 2
Insulation strength Overvoltage category III according to VDE 0110
Packaging DIN 55468 for transport packaging materials
Type of protection IP 20
Approvals CE: Low-Voltage Directive; UL
*climatic conditions according to class 3K3 (EN 50178 Part 6.1)
AHF 005/010 Operating Instructions 3 Specifications
MG.80.C1.02 - VLT ® is a registered Danfoss trademark
11
3