Attaching the Drive Enclosure to the Pedestal
After installing the bottom cover plate, attach the pedestal to
the drive enclosure if it is not attached. To attach the pedestal
to the drive enclosure, use the following procedure. Refer to
Illustration 1.5
and
Illustration 1.6
.
1.
Lift the drive and position it on the pedestal. There
are 2 bolts in the rear of the pedestal that slide into
the 2 slotted holes in the rear of the enclosure.
Position the drive by adjusting the bolts up or down.
Loosely secure with 2 M10 nuts and locking brackets.
See
Illustration 1.5
.
2.
Around the top of the pedestal, secure the enclosure
using 6 M10x30 fasteners. See
Illustration 1.6
. Loosely
tighten each bolt until all bolts are installed.
3.
Fasten each bolt securely and torque to 19 Nm (169
in-lb).
4.
Torque the 2 M10 nuts at the rear of the enclosure to
19 Nm (169 in-lb).
5.
Ensure that the air intake and exhaust vents at the
back of the enclosure are not obstructed. Refer to
Illustration 1.7
and
Illustration 1.8
.
1
Enclosure
2
Pedestal
3
M10 nut
4
Slotted hole in enclosure
5
Bolt at rear of pedestal
6
Locking bracket
Illustration 1.5 Pedestal to Enclosure Back Mounting Points
1
Enclosure
2
Pedestal
3
M10x30 fasteners (rear corner bolts not shown)
Illustration 1.6 Pedestal to Enclosure Mounting Points
Installation Instructions
In-back/Out-back Cooling Kit for E1h/E2h Drives
VLT
®
Series FC 102, FC 103, FC 202, and FC 302
6
Danfoss A/S © 09/2017 All rights reserved.
MI35D102