Installing the Bottom Cover Plate (before Attaching Pedestal)
The bottom cover plate can be installed either before or after
the pedestal is attached to the drive enclosure. The following
procedure explains how to install the bottom cover plate
before attaching the pedestal to the drive. See
Illustration 1.4
.
1.
Remove paper backing from the bottom gasket.
Adhere the bottom gasket to the upper side of the
bottom cover plate.
2.
Position the bottom cover plate and gasket over the
opening at the lower end of the cooling channel.
3.
Secure the bottom cover plate using the M5x14
screws (T25) provided with the kit. Installation in E1h
drives requires 8 screws, and installation in E2h drives
requires 10 screws. Torque screws to 2.3 Nm (20 in-
lb).
1
Cooling channel
4
M5x14 screw
2
Bottom gasket
5
Pedestal
3
Bottom cover plate
6
M10x30 fastener
Illustration 1.4 Installation of Bottom Cover Plate and Pedestal
Installation Instructions
In-back/Out-back Cooling Kit for E1h/E2h Drives
VLT
®
Series FC 102, FC 103, FC 202, and FC 302
MI35D102
Danfoss A/S © 09/2017 All rights reserved.
5