Installing the Bottom Cover Plate (with Pedestal Attached)
The bottom cover can be installed either before or after the
pedestal is attached to the drive enclosure. The following
procedure describes how to install the bottom cover plate
with the pedestal attached. See
Illustration 1.3
. If the pedestal
has not been attached, continue to the next procedure.
1.
Remove paper backing from the bottom gasket.
Adhere the bottom gasket to the upper side of the
bottom cover plate.
2.
Remove the front panel of the pedestal by removing
4 M5x12 screws. Retain the screws.
3.
Inside the pedestal, position the bottom cover plate
and gasket over the opening at the bottom of the
cooling channel.
4.
Secure the bottom cover plate using the M5x14
screws (T25) included with the kit. Installation in E1h
drives requires 8 screws, and installation in E2h drives
requires 10 screws. Torque screws to 2.3 Nm (20 in-
lb).
5.
Replace the pedestal front panel and secure with 4
M5x12 screws previously removed.
1
Drive enclosure
4
Pedestal
2
M5x12 screw
5
M5x14 screw
3
Front panel of pedestal
6
Bottom cover plate
Illustration 1.3 Bottom View of Drive Enclosure and Pedestal
Installation Instructions
In-back/Out-back Cooling Kit for E1h/E2h Drives
VLT
®
Series FC 102, FC 103, FC 202, and FC 302
4
Danfoss A/S © 09/2017 All rights reserved.
MI35D102