D&B D80, Manual

Page: 46 / 80

9.5.1.3.1. System reset
Selecting «Clear all device settings to default» resets all device
settings to factory defaults except for the network (CAN/Ethernet)
and fixed device settings.
To prevent accidental reset when you tap the «Clear...» /
«Clear all device settings» button, a dialog will pop up prompting
you to confirm the reset or cancel the sequence by tapping the
Back button ( ).
Alternative procedure
A system reset can also be triggered as follows:
Note: All device preferences will be set to factory defaults
except for the network (CAN/Ethernet) and fixed device
settings.
If you execute this procedure, no dialog will be prompted and
the reset will start immediately.
1. Switch off the device.
2. Press and hold the encoder and repower the device.
Þ
Long confirmation beep.
3. Release the encoder and briefly press the encoder again
within 2 sec.
Þ Short confirmation beep.
The device will boot up and will switch to the Home
screen. A corresponding message will be issued:
9.5.2. Info
Selecting «Info» provides basic information about the device.
The information provided is mainly intended for service purposes.
Most of the information is static information, for example:
–
Various firmware versions (Firmware Core/DSP/PS/AMP)
– Serial number
– Owner
In addition, there is dynamic information about the actual
temperatures of... :
–
Power supply (Temp. PS)
– The entire power amplifier (Temp. AMP)
– Central Processing Unit (Temp. CPU)
d&b D80 Manual 1.8 en 46