5.1. DS10 configurations
The DS10 in combination with the I/O panel is supplied in a pre-
wired configuration.
The digital outputs (OUT 1/2 and OUT 3/4) are linked to the
corresponding input sockets (A2 D1/2 and A4 D3/4) of the I/O
panel to feed the digital audio signals to the amplifiers.
In addition, the ETH 3 connector of the DS10 is linked to the ETH 1
connector of the I/O panel to provide access to the amplifiers.
The DS10 in combination with the I/O panel allows various
configurations. Two recommended configurations are detailed
below.
Note: For detailed information on how to configure the
DS10, please refer to the DS10 manual, which can be
downloaded from the d&b product page at
.
Ensure the BYPASS/NETWORK switch of the DS10 is set to
NETWORK.
PRI + OCA on separate LANs
DS10 mode*: Red VLAN
*DS10 factory default configuration
PRI + OCA on the same LAN
DS10 mode: Red Multicast Filter
5. DS10 and I/O panel
d&b Z5576.000 Manual 1.1 en
13
Summary of Contents for Z5576.000
