d&b audiotechnik Z5576.000, Manual

Page: 10 / 22

4.1. Intended use
The Z5578 Loudspeaker connector panel acts as a connecting
interface providing all output channels of each amplifier on its
dedicated NL8 socket (4 channels) and two LKA25 connector
sockets (12 channels each), which directly integrate into the d&b
MC24 multicore system.
It is a class 3 wiring unit with IP class 20 (NOT rain-, drip-, or
splash-proof!).
The Z5578 Loudspeaker connector panel must not be used for any
other purpose or outside the system rack.
4.2. ETH/POE INCLINOMETER
A POE (
Power Over Ethernet) enabled etherCON ®
(RJ 45)
connector is available. It is intended to feed an inclinometer which
is integrated in the flying frame for vertical aiming of the entire
array.
E8106 POE Injector device
In connection with the ETH/POE INCLINOMETER socket, a
corresponding IEEE802.3af compliant and prewired POE Injector
device is mounted at the top left rear of the rack assembly. The
device features an LED indicator providing the following status
information:
Solid green: Valid IEEE802.3af load detected and
connected "ON".
Flashing green: Power "ON" ready for connection.
Flashing green/red: Invalid load connected.
Flashing red: Error.
E8106 Technical specifications
Output voltage 56 VDC (±5%)
Minimum load 10 mA
Maximum load 350 mA
Pin assignment Pin 3/6: + | Pin 1/2:–
Compliance IEEE802.3af
4. Z5578 LS connector panel 6 x NL8 / 2 x LKA25
d&b Z5576.000 Manual 1.1 en 10