Danby Premiere DDR70A1GP, Owner'S Manual

Page: 7 / 27

,oocm
OPERATING INSTRUCTIONS (cont'd)
START OPERATION
1) Place the product in an upright
position on a flat, stable, ana neat-
resistant surface. Make sure there is
nothin2 flammable or heat sensitive
within
(39
inches).Onerating
the product in any other position coUld
cause a hazard
2) Insert the plug into a suitable wall
socket. The dehUmidifier is suitable for
rating
on an electricity supply
having tlie same voltage as tliat showm
on
its
rating label.
3)
Make sure the water
tank
is correctly
located.
After
switchinon the machine
for the first time,
if
the 'Bucket
Full''
L l] :t' t;rer
is
able to move freely, then return the
water
tank
to
the correct position
(Fig. 1).
WATER FULL
INDICATOR
LIGHT (RED)
When the water
tank
is full and/or incorrectly positioned inside the cabinet, the water
full
red light
turns
on and remains on until such time that the
tank
is emptied and/or
correctly re-positioned
This condition will result in
the
immediate shut down of the dehwnidifving system (both com_pressor
and
fan
motor erations are terminated).This is a safety feature. When the walerfarik is emptied andlor correctly
re-positioned, the dehumidifier
Will
resume operation automatically.
NOTE:
It may
take
several minutes before operating conditions resume.
BUCKET
FULL LIGHT
• When the water tank is full the machine will stop and the"Bucket
Full,
light will
illuminate.
• The water tank should be carefully removed from
the
machine by slid4tg it outward
from the front of the unit, and it shOuld be emptied. When
the
eJ!!P.1y
tank: is replaced
properly in
the
machine, the unit will start up and run normally (¥ig. 2).
NOTE:Please use both hands
to
carefully empty the water tank.
FACTORY
DEFAULT SETTING
Humidity Setting:60%
Fan
Speed:
Low
Each
time
the unit
is
disconnected/re-connected and/or in the event of a power failure,
the electronic circuitboard automatically defaults
to
1he
following
factorY
setting:
prosetting was different from
the
above (default
setting) it will 'be neces
to
re-proyour
settings.When the unit is switched
"Off"
manually
NOTE:In
the event of a power failurehall previous
settings are automatically erasedlcance ed
lf
your
(using the on/off
keypad)
the unit will always default
to
the last
program
setting that was used
WATER TANK
ProJJC!:
installation of the water
tank is
crucial in maintaining reliable dehumidifier
OPERATION
on.
The water
tank
holds accumulated condensed water anc;
!>Y
means of a safety
switch, controls both the water level and operation of the dehumidification process.
When the water
tank.
is full and/or accidentally displaced inside the cabinet, the float switch actuator (inside
the
tank)
breaks contact with the safety switcli.This condition results in the immediate shut down of the
compressor and
fan
motor system, preventing moisture from being condensed.
NOTE:
Never tamper with or attempt
to
defeat the
water level (safety) float switch system.