OPERATING INSTRUCTIONS
3
LOCATION
Select a location with a strong level floor that can
support the weight of the appliance and the plants
grown inside.
Allow 5 inches (12.7 cm) between the back of the
appliance and the wall. Allow 1 inch (2.5 cm) of
space between the sides of the appliance and any
adjacent walls.
Avoid direct sunlight and heat. Direct sunlight may
affect the acrylic coating of the appliance or the
growing cycle of your plants. Nearby heat sources
can overheat the unit and cause high internal
temperatures that may harm your plants.
Ensure that the appliance is turned off and
unplugged before any changes are made to the
light system.
Keep the door closed during operation.
Only use genuine spare parts from Danby or those
that have been CSA, UL or CE approved.
The LED light panel is not water proof. Do not spray
water on the surface, sides or back of the light
panel.
Do not look directly at the LED light with the naked
eye as this can cause retinal damage.
Recommended ambient operating temperature is
between 13
°
C - 32
°
C (55
°
F - 90
°
F).
Recommended operating humidity is below 80%.
The LED panel cannot be exposed to corrosive
materials.
The LED panel is for indoor growing only and
should not be used outdoors.
Do not touch the surface of the light system while the
power is connected as it can get hot.
Do not use the LED panel during a thunderstorm to
avoid a surge that could damage the light system.
FEATURES
1. LED grow light system
2. Air outlet
3. Control box
4. Drip tray (x2)
5. Wire shelf (x2)
6. Air inlet
7. Adjustable foot
8. Glass door
LEVELING INSTRUCTIONS
There is an adjustable foot on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling foot counter-clockwise until
the top of the foot is touching the bottom of the
cabinet.
2. Slowly turn the leveling foot clockwise until the
appliance is level.
1
2
3
4
5
6
7
8
