20
GEAR UNITS WITH “K” TYPE SHAFT
Dana Incorporated
IMM-0005EN Posiplan (MT-5215-0806)
MACHINE SHAFT WITH NO SHOULDER
Assembly:
align the axes of the gear unit female shaft (pos. 2) as much as possible with the machine male shaft (pos. 1), then bring the two
shafts together after aligning the connecting spline.
Slot them together without exerting too much pressure on each part.
To make sure the female gear unit shaft is tight against the machine shaft use a threaded rod (pos. 4) of an appropriate size.
Now insert the backplate (pos. 3) then the inner retaining ring (pos. 5) into their relative seats and tighten the threaded bar to
bring the two shafts tight against each other (see fig.9).
Securing:
unscrew the threaded rod (pos. 4) and take it out of its seat. Replace the rod (pos. 4) with screw (pos. 6), torquing it down fully
to the torque value shown in "Values Table Torque Setting Bolts p. 32", using an intermediate threadlocker. Dana Incorporated
recommends LOCTITE 601 (see Fig. 11).
Fig. 8
Fig. 9
Fig. 11
2
5
3
7
5
1
2
3
8
4
8
6
