Dan Dugan Sound Design E, User Manual

Page: 10 / 48

Dugan Model E User Guide Quickstart
10
Digital I/O
The Model E may be connected to a digital mixing board with ADAT connections that
transmit eight channels on each digital audio optical cable. Connect the console ADAT
output to the Model E
LINK IN , and the Model E LINK OUT to the board’s ADAT
input. On the mixing board, insert the ADAT inputs and outputs on each mic channel,
post-fader.
Figure 2-2 Digital connection
Step 2 Power-up Commnads
The Model E can execute six commands during power-up. Each command is selected
by holding down a specific button during the entire power-up process. Power-up is
complete after the
bypass LEDs light sequentially and extinguish. The three com-
mands shown below are the most common. See Power-up Commands on page 17 to
learn about the additional modes.
Reset Audio
Hold the channel 1 bypass button down to set all parameters to factory default settings,
clear label text, and set the I/O to analog. We recommend starting an installation in this
mode.
Digital I/O
Hold the channel 3 bypass button down to switch all I/O to the ADAT link connectors.
Linking is not possible and the analog connectors are inoperative.
Analog I/O
Hold the channel 3 mute button down to switch all I/O to the analog connectors. Digital
connectors are available for linking.