CLEANING AND MAINTENANCE
Routine cleaning and maintenance is recommended
CLEANING AND MAINTENANCE OF CONTROL BOX
• Cut the power
• Remove any dust and dirt
• Do not rinse with running water
• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with
an abrasive effect
CLEANING AND MAINTENANCE OF TAP/SENSOR
• Do not rinse with running water
• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with
an abrasive effect
• Clean sensor for dust and dirt to prevent unintentional activation
REPLACEMENT OF DISINFECTANT BOTTLE
• Use the key supplied to open the door
• Remove empty bottle from the rack
• Replace with new bottle
• Insert pump tube into the bottle
• Close the door
TROUBLESHOOTING AND CORRECTIVE ACTIONS
SYMPTOM
POTENTIAL CAUSE
CORRECTIVE ACTION
No disinfectant is
delivered
Low supply
Refill the disinfectant bottle
Sensor window is dirty
Clean the sensor window
Obstruction in front of the
sensor window
Remove the obstruction
Damaged sensor
Contact DAN DRYER for advice
Tube disconnected from pump If the end of the tube is damaged,
please remove the damaged part. The
undamaged tube is to be mounted on
the nozzle exit of the pump
Sensor cabling disconnected
from control box
Check that the cable from the faucet
is installed correctly in the control box
Power supply has been
disconnected
Check that the cable from the adapter
or the external battery box is installed
correctly in the control box (see page
7)
AC/DC adapter not connected
Check that the AC/DC adapter is
plugged into the wall and is getting
power
The dispenser
activates
unintentionally
Sensor window is dirty
Clean the sensor window
Obstruction in front of the
sensor window
Remove the obstruction
Damaged sensor
Contact DAN DRYER for advice
12
13
