!
WARNING
• All units must be equipped with a 3-wire service. Connect the ground wire according
to the instructions.
•
This product must be installed only by qualified persons.
Use 2.08 mm2 (AWG) NO.14 wiring.
• Turn off the power to the unit before servicing or cleaning. All wires must be
disconnected.
• Incorrect installation, defect power cords, or failure to properly ground unit could result
in electrical shock or life-threatening injuries.
• Never modify the product.
• Never insert objects into any opening in the product.
• The product is not intended for playing purposes.
• Cleaning and user maintenance must not be carried out be children.
• The product may only be used for the applications described in this manual.
• Do not use any accessories not recommended by the manufacturer.
• The product should be checked on a regular basis. Never use a defective or
malfunctioning unit.
• Never make alterations to the product affecting its performance. DAN DRYER’s product
warranty does not cover product problems that result from misuse or alteration.
NOTE
Type Y connection: If the power supply cord is damaged, it must be replaced immediately.
Only qualified persons shall be permitted to replace the cord to avoid a hazard. Disconnect
the electricity supply cord according to instructions.
This product is not intended for use by persons (inclusive children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are
supervised or have been given instruction concerning use of the product by a person
responsible for their safety.
Children should be supervised to ensure this product is used correctly.
GENERAL SAFETY INFORMATION
CIRCUIT DIAGRAM
4
5
