22
S-Cube - Primary functions and setup
1. Individual Stereo Speaker
If you wish to use an individual speaker, you
can do so either using Bluetooth of AUX in.
2. Multi speaker setup
To use the S-Cube in
Bluetooth mode. Power
on. Change the S-Cube
to Bluetooth mode. This is
a short press of the Power
button, followed by a pause
for a few seconds. You will hear
a few short beeps. The LED
in the d logo is dark blue to
indicate is in Bluetooth mode.
You will now see the S-Cube
in the Bluetooth settings of
your streaming device which
you can connect to.
Select a primary S-Cube
to connect to your device.
Power on the S-Cube and
connect it to your device as
per step 1a of “1. Individual
stereo Speaker.
Power on additional S-Cube
speaker(s) and change
function to JetStreamNet
mode (light blue LED).
Bring the additional speakers close to the primary speaker
and short press the JetStreamNet (JSN) pairing button
on the primary and secondary speaker at the same time.
Speakers are now connected. Repeat for up to 16 speakers.
Change the output of each S-Cube. Select Triangle for
stereo left channel and square for stereo right channel.
Select Circle on each S-Cube if you wish to play stereo on
each speaker.
To connect your S-Cube to a
device using a AUX/3.5mm
cable, insert the cable into the
AUX port. The LED in the d
logo will change to yellow.
The S-Cube function mode
should be set to Circle.
DC
AUX
DC
1a
1
2
3
1b
2
PLEASE NOTE:
the S-Cube will
start up in the mode it was last
used in.
PLEASE NOTE:
to switch
between the modes it is a
short tap of the power button
the LED will be colourless for
approximately 5 seconds.. The
mode will then change with the
correct LED colour displayed.
