14
Instructions for 5.1.2 setup using one HDMI
PLEASE NOTE BEFORE
COMMENCING SETUP
On initial set up it is recommended
to connect the power supply of
the S-Woofer last as this provides
auto-power upon initial setup. If the
S-Woofer is powered up before the
other speakers are connected, you
will need to power off the S-Woofer
either by removing the power cable
or pressing the power button on the
remote control until the LED turns
off, then power on the system using
the remote control.
PLEASE NOTE:
The S-Cubes are
set up to power on automatically
to the surround sound system only
when connected to a power supply.
Insert batteries into
Remote Control.
Position the S-Bar in
front of the display (TV/
Projector), connect power
cable (3000mAh).
Couple the Dolby Atmos
speaker (S-Atmos) onto
the S-Bar. It will snap into
place. Position the speaker
as per the description
on the “General speaker
placement” page.
Using a high speed HDMI
cable (not supplied), insert
the HDMI source into the
S-Woofer HDMI input 1.
E.g. connect S-Woofer to
a source such as Set top
box, Cable, Xbox, FireTV,
BluRay etc.
Connect the S-Woofer to an output source e.g. TV or
projector, using an high speed HDMI cable. Place one end of
the cable into the HDMI output on the back of the S-Woofer
and the other end into your TV/Projector.
Connect the power
supply to the S-Woofer
(2000mAh). The d
logo on the front of the
S-Woofer will turn red.
The system will now power
up and configure itself. The
S-Woofer LED in the d logo
will turn red. The LED in
the S-Bar d logo will light
up red and the LED on the
S-Cubes logo will display
light blue.
Select a location for the
first S-Cube surround
speaker, connect power
cable (1500mAh). For left
surround move switch on
S-Cube to Triangle.
Select a location for the
Second S-Cube surround
speaker, connect power
cable (1500mAh). For
right surround move the
switch on the S-Cube to
the Square.
DC
2
DC
3
4
5
6
8
9
AAA
1
AAA
S-Woofer
S-Bar
S-Cube
7
