Dalsa spyder SG-10-01k80, User Manual

Page: 87 / 112

Spyder3 GigE User’s Manual PRELIMINARY
DALSA 03-032-10158-04
87
A4.6 Returning the LED Status
Purpose: Returns the status of the camera’s LED.
Syntax:
gsl
The camera returns one of the following values:
1
= red (loss of functionality)
2
= green (camera is operating correctly)
5
= flashing green (camera is performing a function)
6
= flashing red (fatal error)
Notes: •
Refer to section
292H
2.5 Camera LED for more information on
the camera LED
A4.7 Returning Camera Settings
Returning All Camera Settings with the Camera Parameter
Screen
The camera parameter (gcp) screen returns all of the camera’s current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
gcp
GCP Screen Description
GENERAL CAMERA SETTINGS
Camera Model No.: SG-10-01K80
Camera model number.
Camera Serial No.: xxxxxxxxx
Camera serial number.
Firmware Version: xx-xx-xxxxx-xx
Firmware design
revision number.
CCI Version: xxxxx.xx
CCI version number.
FPGA Version: xxx.xx
FPGA revision number.
UART Baud Rate: 9600
Serial communication
connection speed set
with the
120H
sbr
command.
See
293H
Setting Baud Rate
on page
294H
53 for details.
Dual Scan Mode: High Sensitivity
Current sensitivity
mode set with the
121H
shm
command. See section
295H
A1.1 Sensitivity Mode
for details.
Camera Mode: 2 taps, 8 bits
Current bit depth
setting set with the sdm
command. Refer to
section
296H
A1.3 Setting the
Bit Depth for details.