Dalsa spyder SG-10-01k80, User Manual

Page: 101 / 112

Spyder3 GigE User’s Manual PRELIMINARY
DALSA 03-032-10158-04
101
Mnemonic Syntax Parameters Description
set GPIO input
sgi
i i
Sets the GPIO input signal.
i
= input number in a range from
0
to
3
i
= signal to use where:
0
= disabled
1
= TTL
2
= LVDS
set GPIO output
sgo
i i
Sets the GPIO output signal.
i
= output number in a range from
0
to
3
i
= output signal to use where:
0
= disabled
1
= TTL
2
= LVDS
set lower threshold
slt
i
The pixels below the lower threshold
are checked for and reported in the
end-of-line sequence in a range from
0
-
4095
.
set prnu coeff
spc
x i
Set the PRNU coefficient.
x
=pixel number within the range
1
to
sensor pixel count
.
i
= PRNU value within the range
0
to
28671
.
set subtract background
ssb
t i
Subtract the input value from the
output signal.
t
= Tap value.
0
for all taps or
1
to
number of camera taps
for individual tap
selection.
i
= Subtracted value in a range from
0
to
4095
.
set sync frequency
ssf
i
Set the frame rate to a value from
300
Hz to
37000
Hz (2k model) or
300
Hz to
68000
Hz (1k model). Value
rounded up/down as required.
set system gain
ssg
t i
Set the digital gain.
t
= tap selection, either
1
to
2
, or
0
for
all taps
i
= Digital gain in a range from
0
to
65535
. The digital video values are
multiplied by this number.
set sensitivity mode
ssm
i
Sets the camera’s sensitivity mode
where i is:
0
= Low sensitivity mode
1
= High sensitivity mode
2
= Tall pixel mode
set upper threshold
sut
i
The pixels equal to or greater than the
upper threshold are checked for and
reported in the end-of-line sequence in
a range from
0
-
4095
.