Dalsa spyder SG-10-01k80, User Manual

Page: 27 / 112

Spyder3 GigE User’s Manual PRELIMINARY
DALSA 03-032-10158-04
27
Figure 13: LVDS Input
100
Ω
Figure 14: LVDS Output
Programming the GPIO Connector
The connector is programmed through the QuickCam application or through the
QuickCam SDK. After you have installed the QuickCam program, refer to the QuickCam
User’s Manual or the QuickCam help topic, GPIO Control, for more information on
programming the connector. Refer to section
232H
3.1 QuickCam Interface for more
information on installing QuickCam.
2.5 Camera LED
The camera is equipped with a red/green LED used to display the operational status of
the camera. The table below summarizes the operating states of the camera and the
corresponding LED states.
When more than one condition is active, the LED indicates the condition with the highest
priority. Error and warning states are accompanied by corresponding messages further
describing the current camera status.
Table 6: Diagnostic LED
Priority Color of Status LED Meaning
1 Flashing Red Fatal Error. For example, camera temperature is too
high and camera thermal shutdown has occurred.
2 Solid Red Warning. Loss of functionality
3 Flashing Green Camera initialization or executing a long command
(e.g., flat field correction commands
ccp
or
ccf
)
4 Solid Green Camera is operational and functioning correctly