Dalsa S3-10-01k40-R, User Manual

Page: 19 / 115

Spyder 3 CL User's Manual 19
DALSA 03-032-20008-00
2.4 Camera LED
The camera is equipped with a red/green LED used to display the operational status of
the camera. The table below summarizes the operating states of the camera and the
corresponding LED states.
When more than one condition is active, the LED indicates the condition with the highest
priority. Error and warning states are accompanied by corresponding messages further
describing the current camera status.
Table 4: Diagnostic LED
Priority Color of Status LED Meaning
1 Flashing Red Fatal Error. For example, camera temperature is too
high and camera thermal shutdown has occurred.
2 Flashing Green Camera initialization or executing a long command
(e.g., flat field correction commands
ccp
or
ccf
)
3 Solid Green Camera is operational and functioning correctly
2.5 Camera Link Data Connector
Figure 10: Camera Link MDR26 Connector
MD R26 Female
1
14
13
26
M at ing Par t : 3M 334-31 ser ies
C able: 3M 14X 26-SZ LB-X X X -0LC * *
The Camera Link interface is implemented as a Medium or Full Configuration in the
Spyder 3 cameras. Refer to section Setting the Camera Link Mode for details on setting
the Camera Link configuration.
Table 5: Camera Link Hardware Configuration Summary for Piranha HS-xx Models
Configuration 8 Bit Ports
Supported
Serializer
Bit Width Number
of Chips Number of
MDR26
Connectors Applicable
Camera
Models
Base A, B, C 28 1 1 The various
models
**3M part 14X26-SZLB-XXX-0LC is a complete
cable assembly, including connectors.
Unused pairs should be terminated in 100
ohms at both ends of the cable.