dallmeier CaminPIX DDF4010HDV-IM, Manual

Page: 56 / 76

DDF4010HDV
www.dallmeier.com 56
10.3.2 encoder 2
encoder 2 is disabled by default.
Note that the encoder 2 option is dependent on the set frame rate and resolution of en-
coder 1 .

Select the encoder 2 tab.
Fig. 10-7

If required, activate the Use encoder checkbox to enable Encoder 2.

Select the required settings (see section “ Encoder 1 ” on page 54).

Confirm with oK .
10.3.3 Audio
Audio encoding is not supported in this software version.
The audio bit rate setting allows you not only to control the audio quality, but also the
amount of required hard disk space to a certain extent. The higher the audio bit rate, the
better the audio quality. A higher bit rate, however, requires more hard disk space than a
lower bit rate.

Select the Audio tab.
Fig. 10-8

Select the Audiobitrate .

Confirm with oK .