dallmeier CaminPIX DDF4010HDV-IM, Manual

Page: 23 / 76

DDF4010HDV
www.dallmeier.com 23
6.2 Surface Mount Variant
The housing base is mounted with 3 screws (Ø 4 mm) to the ceiling/wall.
You need:
• T20 torx wrench
• Marking tool (e.g. awl)
• 3 mounting screws (Ø 4 mm)
• 3 anchors
• Electric drill
• Screwdriver

Unscrew the 3 housing screws (Fig. 5-5) using a T20 torx wrench and remove the
housing.

Unscrew the securing screws of the spring clips (Fig. 5-7) and remove the plug-in mod-
ule while pushing the spring clips slightly together.

Mark the drill holes on the ceiling/wall using the 3 pre-drilled mounting holes of the
housing base as a template.

At the marked locations, drill holes fitting for the screws/anchors to be used.

Push anchors suitable for the ceiling/wall material in the drill holes.

Run the required cables suspended from the ceiling/wall through a PG16 cable gland.

Screw the PG16 cable gland in the appropriate thread of the housing base (Fig. 5-6).

Connect the required cables to the connectors of the terminal area in the housing base
(see chapter “ Pin Assignment ” on page 69).

Mount the housing base with 3 screws to the ceiling/wall.
Ceiling/Wall
Drill hole
Anchor
Mounting screw (Ø 4 mm)
Fig. 6-6