13
UK
DE
DK
c)
VOLuME adjustment: turn the button towards “Max” to increase the sound level. to reduce
the sound level, turn the button towards “Min”.
D)
cROSSOVER: Adjustment of the crossover frequency from 50 Hz to 150 Hz. to be able to
adjust the crossover frequency, the MODE selector must be set to NORMAL (see B).
E)
PHASE: push the PHASE button to toggle the phase of the subwoofer to either 0 degrees or
180 degrees phase angle.
F)
LINE input: (MODE selector set to NORMAL): connect the “L” input connector (white)
to the LEFt RcA line output connector of your stereo/surround sound (pre-) amplifier.
connect the “R/LFE” input connector (red) to the RIGHt RcA line output connector of your
stereo/surround sound (pre-) amplifier. LFE input: (MODE selector set to LFE): connect the
“R/LFE” input connector (red) to the LFE RcA line output of your surround sound amplifier.
G)
POWER switch: Set the switch to ON to power up the subwoofer. Set the switch to OFF to
power off the subwoofer.
H)
VOLtAGE selector: Set the VOLtAGE selector to match the voltage of your mains supply.
CAUTION: If the voltage selector is not set correctly there is a risk that the electronics of
the subwoofer will become defective when the subwoofer is connected to the mains.
I)
FuSE compartment: If the subwoofer fails to power up when the connected to the mains and
the POWER switch is set to ON, the fuse may have blown or be faulty. Replace the fuse with
the same type as originally supplied – see fuse type on the amplifier back plate. If the fuse
blows repeatedly, have the subwoofer checked at an authorised service centre – contact
your authorised dealer. check if the correct voltage has been selected.
J)
MAINS connector: connect the supplied power cord to the MAINS connector and your
mains outlet.
WARNING: MAKE SURE THAT THE VOLTAGE SELECTOR IS SET TO THE CORRECT
VOLTAGE BEFORE CONNECTION.
K)
there are three settings for the POWER MODE switch: ON:the power to the subwoofer
will be controlled by the POWER switch. AutO: When the main power switch is on, the
subwoofer amplifier will turn on when an input signal is detected on one of the inputs. When
a signal is not detected for approximately 10 minutes, the subwoofer amplifier will go into
standby-mode. OFF: the subwoofer will be powered down.
1 1 . 0 T E C H N I C A L S P E C I F I C A T I O N S
In table 2 you will find the most common specifications for our subwoofers. Please have in mind
that there are countless methods for measuring subwoofers. However, none of them really tell you
anything useful about how a subwoofer really sounds. Only your ears can decide whether one sub
sounds better than another. Like all our speakers, DALI FAZON SuB 1 is designed to reproduce
music as honestly as possible.
Enjoy your new DALI FAZON SuB 1!
