12
5.5 ON/STAND BY
the subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an
input signal is detected (given that the POWER is set to ON). When the subwoofer is ON, the ON/
StANDBY LED will light green. If an input signal is not detected for approximately 20 minutes, the
subwoofer will go into standby mode and the ON/StANDBY LED on the rear of the subwoofer will
light red.
6 . 0 R U N N I N G - I N
You should expect the sound quality from your new subwoofer to gradually improve during the
initial period of use. Nothing particular has to be done in order to run in the subwoofer – but
expect up to 100 hours of playback (depending on playback level) before full performance level is
reached. use normal music for running-in the subwoofer.
7 . 0 O V E R L O A D I N G
If DALI FAZON SuB 1 is overloaded, the built-in safety circuit will power down the subwoofer and
the LED on the back of the product will turn to red. the subwoofer will power on again when the
temperature of the built-in amplifier is within the safe working range.
NOTE:
the built-in safety circuit is no guarantee against damage as a result of overloading.
8 . 0 M A I N T E N A N C E
cleaning the subwoofer surfaces can be done with ordinary household cleaning agents and using
a micro fibre cloth. Avoid using products that are abrasive or contains acid, alkali or anti-bacterial
agents. Avoid using aerosols. Avoid using cleaning agents directly on the drive unit and clean these
with extreme care.
8.1 AVOID DIRECT SUNLIGHT
the surfaces of the subwoofer may fade or become discoloured over time when exposed to direct
sunlight. therefore avoid positioning the subwoofer in direct sunlight.
9 . 0 D I S P O S A L
DALI products are designed to meet the international directives concerning Restriction of Hazardous
Substances (RoHS) and disposal of Waste Electrical and Electronic Equipment (WEEE). the waste
symbol indicates that the speakers meet the directives (see Figure 2). the subwoofer must be
processed or recycled appropriately. Please consult your local waste authority for guidance.
1 0 . 0 A M P L I F I E R B A C K P L A T E ( F I G U R E 3 )
A)
ON/StANDBY LED, indicator is green when POWER is set to ON and when an input signal on
the LINE INPut(S) is detected. the LED is red, if the subwoofer is powered down on standby.
B)
MODE selector: When the MODE selector is set to NORMAL, the built-in crossover will be
active and you can adjust the crossover frequency on the cROSSOVER button given that
the input signal is connected to the LINE INPut L (or both L and R/LFE). When the MODE
selector is set to LFE, the LFE input signal should be connected to the LINE INPut R/LFE. In
this case, the built-in crossover will be bypassed and the cROSSOVER button is not active;
the subwoofer sound must be adjusted from the stereo or surround sound (pre-) amplifier.
