TRIMAX 520
Page 29
Hydraulics
All hydraulic hoses must be checked for wear, tear and breakage. Ensure the
hoses are not subjected to any crushing.
If left parked for longer periods of time, protruding plunger rods should be
greased with oil or pressure grease, in order to avoid the build-up of rust on
the plunger rod. Remember to remove it again before use.
Disc pivot
The disc pivots should be tightened once a year or as needed.
Fig. 18
1.
The disc is removed.
2.
The split in the pivot nut is
removed.
3.
The pivot nut is tightened a
quarter of a turn or until
there is no more deviation in
the pivot.
Wear parts. Tines
The tips of the tines on the TRIMAX can be turned around and this must be
done before there is any wear and tear on the console onto which the tines are
clamped.
The tips of the tines must be replaced once the wear and tear is significant
enough to cause the result of the fieldwork to be unsatisfactory or before any
wear and tear on the console can be detected.
Always make sure to use original spare parts from Dalbo A/S