DALBO POWERCHAIN 800, User Instructions, Page: 51 / 55

POWERCHAIN
Page 51
The wheel nuts are removed and the wheel can be replaced. After fitting the
new wheel, screw the nuts on and tighten with a “firm hand”. Next, lower
the wheels so that they are touching the ground and tighten the nuts to
300 Nm.
It is important that the wheel nut and bearing surfaces are clean, otherwise,
the wheel nuts may loosen.
It is important that the lifting device can handle a minimum of 75% of the
machine’s total weight. In addition, the machine must be properly braked
and secured.
Removing/mounting wheels in the field
To remove wheels, unfold the disc harrow with the disc chains resting on the
ground. Then support the machine at the points (A) fig. 30, and the wheels
will then be free from the ground.
Fig. 31
The wheel nuts are removed and the wheel can be replaced. After fitting the
new wheel, screw the nuts on and tighten with a “firm hand”. Next, lower
the wheels so that they are touching the ground and tighten the nuts to 300
Nm.
It is important that the wheel nut and bearing surfaces are clean, otherwise,
the wheel nuts may loosen.
A
A