MAXIROLL
Side 15
Adjusting the middle section
Fig. 4
With MAXIROLL in an unfolded position
(see “Operating and Driving Instruc-
tions”), check if the bolts (A) is touch-
ing the tube (B).
This control must be made with the
MAXIROLL attached to the tractor. And
after the drawbar end bracket hitch is
adjusted for the towing tractor.
Fig. 5
The pendulum on the middle section
must at the same time be flush, with
the adjacent fixed frame part.
It is important to locate the MAXIROLL
on
level
ground in order to set the
middle section correctly.
If the bolts (A, Fig. 6) is not touching the tube and the pendulum is not flushed with
the adjacent fixed frame part, the bolts must be adjusted.
Fig. 6
1.
Loosen the locking nut (A).
2.
Adjust the bolt (B).
3.
Tighten the locking nut (A).
4.
Check the pendulum and that the
towing height is correct.
5.
The bolt (B) must touch the tube.
Otherwise drive the tractor a little
forward and check the settings.
Adjusting wing fold stop
Fig. 7
To ensure the correct transport posi-
tion of the wing sections, it is possi-
ble to adjust the backstop (A) for the
wing sections.
A
B
A
A
B
A
Summary of Contents for MAXIROLL 530
