DALBO MAXICUT, Manual, Page: 21 / 30

MAXICUT
Side 21
Replacement andrepairs

Safety is vital for all repair work on the roller. Always observe the following points,
plus those under Safety First in the instruction manual.
All maintenance and repair work can only be performed when the machine is low-
ered to the ground or locked in transport position, tractor is braked, engine stopped
and ignition key removed to prevent accidental start.
Particular attention must be paid to safety when repairing hydraulics. Before
commencing work, depressurise hydraulic system and support part being worked
on.
Always ensure hydraulic system is bled after repairs and before use to prevent
mechanical breakdown and injury to person.
Hydraulics
Replacing extend cylinder for retracting side sections
Roller must be fully extended and standing on ground for repairs.
Fig. 8
1. Depressurise cylinders (A). Check
there is no pressure shown on the
manometer.
2. Disconnect hoses.
3. Remove split pins and pins. Cylin-
der will now be free.
4. Fit new or repaired cylinder.
Check pin locks into place, secure
pins with split pins.
5. Connect hoses. Check there is no
danger of hoses being ripped or
crimped after fitting.
A