Daktronics PC-2002, Manual

Page: 10 / 34

Electrical Installation
6
9� Route the brass antenna connector through the “D” hole in the side of the display
cabinet. Slip on the washer and nut on the outside of the display, and then tighten
the nut using a 5/16 wrench. Screw the black antenna onto the brass connector.
Ensure the antenna is pointed straight up. Refer to Figure 8 .
Figure 8: Radio Receiver Installed
10� CAREFULLY close the front and rear panels. Ensure that no wires are pinched
between the metal panels. It may be necessary to disconnect the 6-pin power/signal
cable from the radio receiver unit and coil it up to fit inside the display.
11� Reinsert/tighten the 10 Phillips screws.
12� During operation, ensure the radio antenna stays pointed straight up.
For more information about the wireless radio control option, refer to the Gen VI Radio
Installation Manual (DD2362277) , provided with the receiver unit and available online at
www.daktronics.com/manuals .
Radio Settings
With a radio receiver installed in the display, watch for the radio Broadcast settings (“b1”)
and Channel settings (“C1”) during the Power-On Self Test (POST).
These values must match the settings in the control console:
If the radio receiver channel and broadcast settings match those set in the console but
the console does not control the display, there may be radio interference. This can occur
when a nearby display also uses radio control. In this case, change the settings of the
wireless radio receiver inside the display and in the console as described in the radio
control manuals.
RADIO SETTINGS
BCAST 1 CHAN 01