ZX-3
Ultrasonic Thickness Gauge
29
1) With the
ZX-3
powered off, press and hold down the
key while
powering the
ZX-3
on
. The lock icon will be illuminated on the display.
2) To unlock the
ZX-3
repeat step one, but hold down the
key while
powering the
ZX-3
on
.
6.8 Factory Defaults
The
ZX-3
can be reset to factory defaults at any time to restore the original gauge
settings. This should only be used if the gauge is not functioning properly, or
perhaps multiple features have been enabled and a clean start is needed.
The procedure to reset the gauge is outlined below:
Factory Reset
1) With the
ZX-3
powered off, press and hold down the
and
keys
while powering the
ZX-3
on
.
Note:
Once the measurement screen is displayed the
and
can be
released.
2) Press the
keys to scroll through the factory setting options.
3) Make a note of the “MEDI” & “ZERO” settings prior to performing a reset.
These values will need to be entered back in the gauge following the reset.
4) Press the
keys to scroll “REST” (reset).
www.calcert.com
1.888.610.7664
0
5
10
15
20
25
30