MAN #650778
13
VOLT Low voltage warning setup
When >
press and hold either
displayed, and release.
The low voltage warning points will range from 9.0 to 12.1 volts.
Press and release the switch to change the low voltage warning point.
Press
, and release.
Exit setup.
GEAR Gear indicator setup
No programming is required with stock gearing and tire size.
The gauge can learn the gear ratios based on speed and RPM, no additional sensors are needed.
This feature will work with various transmissions up to seven speed models.
The factory preset option will preset the indicator to work with a stock 5 or 6 speed drive train.
With a stock 6 speed, there will be a slight delay the first time you shift to sixth gear as the system verifies the gear.
the gear positions, you will need a stretch of road to gradually reach highway speeds with no interruptions.
Each gear will need the speed to be held steady, until instructed to speed up and shift up.
>> Gear
requires holding the function switch, THEN starting the engine to enter setup <<
Once the engine is running, release the switch.
Press and release the sw
Press and hold the swit
TRIKE , P-1200 , P-883 ,
o
set the gear reading to factory gearing and tire size
o
TRIKE set the gear reading to factory gearing and tire size for a trike application
o
P-1200 set the gear reading to factory gearing and tire size for a 1200cc Sportster/Dyna application
o
P-883 set the gear reading to factory gearing and tire size for a 883cc Sportster/Dyna application
o
starts the leaning process of speed and RPMs to calculate your gear reading.
To reset the gear to n
o
layed, then release the switch.
o
Press and hold again to return to Gear menu.
To start learning gears
>
o
The message wi
if the engine RPM is below 1500.
o
The message could also say
vehicle speed is below 5 MPH.
Begin rid
H
It should only take about 20 seconds if the speed and RPMs are steady.
o
Optional: If
, you can manually override and jump to the next gear by pressing
and releasing the switch to store the gear position quicker.
Upshift to 2nd gear and ride at a steady speed. The display should
Ride
o
Optional: If the
you can manually override and jump to the next gear by pressing
and releasing the switch to store the gear position quicker.
Repeat this through each gear.
When you are done, come to a complete stop.
o
You may also press and hold the switch, while riding, until the display shows MOVE LINE and then release it.
The gears will now show up to the left of the clock display only.
*When downshifting, the gear position may jump up momentarily as the RPM is higher than expected.
The position will begin reading as the bike begins to move in gear
.
FACTORY RESET
In the event you would like to start over with your settings, preferences and display locations, this will reset all settings back to the
out-of-the-box configuration.
This includes message locations, color selections and speedometer calibration but
DOES NOT
include the odometer.
.
.
ll exit the reset menu.
switch.
VERSION
For technical support assistance, this screen can display the model number, and the software versions loaded for the two
processors.
EXIT SETUP
Exits the setup menu and returns to normal gauge operation.