Dakota Digital MLX-9X14 Series, Manual, Page: 10 / 15

MAN #650778 10
OIL TEMP Engine oil temperature setup menu
Only valid to use when optional SEN-1043 or SEN-1044 is used.
When >OIL TEMP displayed, press and hold either played.
The options ar
Press and release to choose an option, then press and hold to select option.
When >UNIT is displayed, press and hold the switch layed, and release.
Press and release the switch to s BACK
Press and hold the switch on the selection, , and release.
.
To enable oil temp, when > is displayed, press and hold the , and release.
The selections will be WARNING TEST BACK
Press and release the switch to change the selection, press and hold the switch to select it.
SENDER Temperature sender selection
When >SENDER ed, , and release.
The display options are SEN-1043 SEN-1044 .
Press and release the switch to match to the optional sender you purchased from Dakota Digital.
Press and hold the switch on the selection, , and release.
HIGH WARNING High oil temperature warning setup
When > displayed, , and release.
The display will show the default high te .
The high temperature warning points range from 225 to 375F, (107 to 190C).
Press and release the switch to change the change the high temp warning point.
Press , and release.
TEST Resistance test
When >TEST , and release.
The display will give a resistance (ohm) reading of the sender. An open will read OPEN ..
Press and release the switch to change the gauge. Press and hold the switch to exit.
Exit setup.
OIL PSI Engine oil temperature setup menu
Only valid when optional SEN-1039 pressure sender is purchased from Dakota Digital.
When >OIL PSI press and hold either switch until is displayed, and release.
The
press and hold the switch , and release.
The selections will be WARNING d BACK
Press and release the switch to change the selection, press and hold the switch to select it.
Low warning Low oil pressure warning setup
When > , and release.
The low pressure options will range from 0 to 30 PSI.
Press and release the switch to change the change the low oil pressure warning point.
To exit, press and h , and release.
TEST Voltage test
When >TEST press and hold the switch unti displayed, and release.
The display will give a voltage return from the sender with 0.5 volts at zero PSI.
0.0 volts means the sensor is not connected.
To exit, press layed, and release.
Exit setup.