Daken D30SS,D60BS,D98BS, Owner'S Manual

Page: 32 / 40

OWNER’S MANUAL
TROUBLESHOOTING
Before troubleshooting or attempting to service, read the following safety rules to avoid
accidental exposure to chemical and also risk of electric shock.
!
WARNING
- 32 -
Note: A reserve, clean container capable of holding at least 38 Litres (SKU # D30SS) or 60 Litres (SKU #D60SS) or 98 Litres (SKU #
D98SS) should be kept for use when the sprayer tank needs to be emptied temporarily for repairs. It is advisable to purchase a
reserve tank suitable for pesticide storage in these circumstances. The container should be properly labeled as to its contents if it is
used.
BEFORE ATTEMPTING TO SERVICE THE SPRAYER
1. Personal
protective
equipment Wear personal protective equipment as directed on the chemical label while servicing your
sprayer.
2. Review
troubleshooting
table Review the Troubleshooting Table below for the type of problem you are experiencing.
However, DO NOT attempt to repair until the steps listed below are followed.
3. Empty and flush Empty the tank and flush the sprayer with water as directed in the section, “Operation –
Step Four.”
In order to avoid accidental exposure to chemicals, never attempt to service the sprayer until the tank
has been emptied and the sprayer flushed with water.
4. Disconnect
power/relieve
pressure Disconnect power to the sprayer and be sure all system pressure is relieved by squeezing the
gun trigger.
5. Perform repairs Follow the directions provided in the troubleshooting table to repair the sprayer.
NOTE: Never try to unclog the sprayer nozzle by blowing through it.
6. Test after
servicing
After servicing, ALWAYS test the sprayer for leaks with plain water before using.
Problem Cause Solution
Pump will not turn on
Bad electrical connection Check battery connections
Fuse blown Replace fuse
Short in wires Check condition of wires
Low voltage Check voltage
Low pressure
Worn spray gun nozzle Replace spray gun
Worn boom nozzle Replace boom nozzle
Low flow
Clogged intake tube Remove obstruction
Clogged suction strainer Clean suction strainer
Low voltage Check voltage
Poor spray distribution
Clogged intake tube Remove obstruction
Suction strainer clogged Clean suction strainer
Worn spray gun nozzle Replace spray gun
Pump cycles while not spraying Leak in the system
Tighten leaking hose clamps or fittings,
replace spray gun