OWNER’S MANUAL
STEP EIGHT: FINISH BROADCAST KIT ASSEMBLY
1.
Push broadcast lance into broadcast bracket. Note orientation.
2.
Install hose barb into open port on pump. Hand tighten, then one-half turn with a wrench.
3.
Connect 60 cm hose from pump to broadcast lance using two hose clamps. Follow hose clamp instructions below.
4.
Thread broadcast nozzle hand tight onto the end of the lance. Note orientation.
Hose clamp installation instructions
1.
Slide hose clamp over the end of the hose
2.
Push the hose onto the hose barb
3.
Slide the hose clamp over the hose barb
4.
Tighten the hose clamp
Hose clamp
Hose barb
STEP NINE: ATTACH SPRAYER TO VEHICLE
NOTE:
If your vehicle battery will be inaccessible after the sprayer is attached, proceed to
“Step Ten: Connect remote switch
to vehicle battery”
prior to performing this step
Secure the sprayer tank to your ATV rack with two tank straps.
Hose clamp
Broadcast lance
ATV rack
(not included)
Tank straps
Broadcast nozzle
ASSEMBLY
- 14 -
