Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
16
REV032019
DANGER - WARNING
TO GET OPTIMUM PERFORMANCE FROM YOUR BLADE, CARRY OUT THE BREAK-IN
PROCEDURE. ALWAYS BREAK-IN THE BLADE USING THE BLADE MANUFACTURES
BREAK-IN RECOMMENDATIONS. IF UNAVAILABLE THESE STEPS WILL PROVIDE
GENERIC BREAK-IN PROCEDURES.
Start out making three cuts, putting only a light pressure on the workpiece.
Light pressure: as an example, consider an operation to cut a solid steel bar (e.g. C40, D .2”
dia). This should be cut in about 4 minutes. Once the blade has been broken-in the same
workpiece can easily be cut in about 2 minutes.
LUBRICATION / COOLANT
The machine does not need lubricating / coolant.
CLEANING
DANGER – WARNING
• Wear suitable personal protective equipment (e.g. safety glasses, etc.).
• Avoid using compressed air.
• Keep saw and surrounding areas clean from debris.
