Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
14
REV032019
INSTALLATION AND ADJUSTMENT OF BANDSAW STOCK STOP
1. Screw the guide rod (10) in the hole on the base.
2. Tighten the nut.
3. Loosen the handwheel and position the holder (10) at the required distance.
4. Tighten the handwheel.
OPERATIONS
DANGER - WARNING
THE MACHINE IS EQUIPED WITH A MAIN POWER SWITCH (located on control box 8) TO
BE ACTIVATED BEFORE THE WORK OPERATION. ONCE WORK HAS BEEN
COMPLETED, TURN OFF THE MAIN POWER SWITCH.
• Never wear gloves while operating saw.
• Before making a new cut, always remove the cut part left from the previous cut.
• Keep hands well away from the cutting area.
USE AS A MANUAL CUTTING SAW
The cutting head must be raised to the maximum up position then brought down to un-lock
the head lock feature. Do not force the head down as this may damage the saw.
1. Secure the workpiece to be cut in the vise using the vise adjusting screw (12).
2. Press button (located in the handle grip1) to start the blade.
3. Lower the cutting head slowly until it comes into contact with the workpiece
DANGER - CAUTION
To avoid breaking the blade, reduce pressure as soon as the blade comes into
contact with the workpiece.
4. Complete cutting until you break through the cut.
5. Release the button to stop work.
6. Lift the head as far as it will go.
DANGER - CAUTION
• Never bring hands anywhere near the cutting area until the blade has stopped and head
has been raised to its full height.
• Let the cut piece fall onto the base of the machine. Do not grab the cut part.
• In the event of excessive cutting pressures, the current limiter will trip, back off the cutting
pressure to safeguard the machine and operator.
