Dake Euromatic 370 PP, Instructions Manual

Page: 17 / 64

370 S 370 S L 370 PP 370 PP L
17
The air pressure can also be reduced by turning the main incoming air regulator down. Turning this down will also
slow the operation of the machine.
WARNING!!!!!
BE SURE CAM IS TIGHT; DAMAGE TO THE MACHINE AND/OR PERSONAL INJURY MAY
OCCUR
Warning!!!!!
Never depress the limit switches with your finger. Your finger could be crushed or amputated
between the limit switch and cam block.
SEMI-AUTOMATIC CUTTING
370 PP / S
Running in the Semi-Auto mode
WARNING!!!!
Always close the safety guard when the machine is in operation.
A: Turn on the main power to the saw.
B: With the 370 PP model turn the cycle selector switch to the semi-auto selection (hand symbol)
C: Turn the security key to the on position (LEFT)
D: Set up and adjust your vises to the material being cut. (See vise set up section)
E: Set up your head parameters. (See head limit section)
F: Place part against positive stop, or position material for correct length to be cut.
WARNING!!!!!
NEVER MOVE THE BLADE SPEED SELECTION KNOB WHILE THE MACHINE IS IN
OPERATION OR WHILE THE GREEN OR YELLOW LIGHT IS ON, IT MAY DAMAGE THE
MACHINE.
G: Select speed. 25 or 50 RPM for ferrous material, 15000 or 3000 for non-ferrous material
H: Close head feed flow control.
I: Press the green start button. (370PP you will need to press the orange button after pushing the green button) Adjust
the head feed rate, and coolant flow to the material being cut.
WARNING!!!!!
Make sure head feed control is closed before starting cycle. Head could overfeed into the part
if this is not followed, causing possible blade and/or machine damage, or may result in personal injury.
The following steps will be executed
1. Vises close and clamp the part.
2. Motor starts, coolant flow starts. Head will descend and make cut.
3. Motor stops, coolant flow stops. Head will return to the preset height.
4. Vise will unclamp part.
VISE SET-UP AND MITER CUTTING
FERROUS HEAD
Miter cutting and Squaring
The 370 PP and 370 S have a scale scribed into the front of the rotating portion of the cutting head (0 to 60 degrees.)
On the stationary portion of the cutting head casting is a scribed line. Any angle can be set by loosening the lock handle. This
handle is located front and center of the cutting head.
Loosen the locking handle, this handle can be pulled and repositioned to clear the coolant tube.