Dake Atmos, Installation, Use And Maintenance Instruction

Page: 17 / 24

USES
PANEL OPENING
It is possible to open the panel, which cover the
grease filters, slightly pulling the panel on a side,
as shown on fig. 1.
In order to make the hood working properly, it is
recommended to install the appliance at a distan-
ce of 2000 - 2100 mm from the floor.
Before starting the appliance installation, please
check that all components are not damaged, in
such a case contact your retailer and do not carry
out installation.
Furthermore, please read carefully all of the fol-
lowing installation instructions.
- Use an exhausting pipe whose maximum length
does not exceed 5 meters.
- Limit the no. of elbows in the piping, since each
elbow reduces the air capacity of 1 linear meter.
(Ex.: if you use no. 2 x 90 ° elbows, the length of
piping must not exceed 3 meters).
- Avoid abrupt direction changes.
- Use a 150 mm constant diameter pipe for the
whole length, or same section.
- Use piping approved by standards in force.
17
SLT970 BRHM
SLT971 BRHM
Take the product out of the packaging and place
it on a suitable surface: we Suggest to use a soft
material, such as a sponge or a cloth.
Open the glass panel , rotating it as shown in Fig.
1.
IN CASE THE HOOD COMES WITH A GLASS
PANEL BEFORE INSTALLATION , IN ORDER
TO AVOID ANY POSSIBLE DAMAGE TO THE
GLASSES, WE RECOMMEND TO REMOVE
THEM BY UNSCREWING THE EIGHT SCREWS
SHOWN IN FIG.2.
Remove the grease filters (Fig. 3).
Unscrew the 4 fixing screws (Fig. 4), separate
the hood frame from the upper part (Fig. 5) and
disconnect the electric cable (Fig. 5A).
Where you intend to install the appliance, you
must create a recess which will have a rectangu-
lar opening of:
850 x 470 per il modello SLT970
865x515 mm model SLT971 Cm.90
1165X615 mm model SLT971 Cm.120
The depth must range from 200 to 280mm.
Make the four holes in the solid ceiling using an
8mm helical bit, following the dimensions in fig.6.
Insert the dowels supplied in the holes made.
Insert the threaded rods in the previously instal-
led dowels.
Screw the threaded rods using two nuts, as
shown in fig. 7, act in the low nut to screw the
threaded rod.
Insert an additional nut and the plastic locking
washer as shown in figure 8.
It is crucial, for a correct installation, to place the
metal washer 200mm high from the bottom surfa
ce of the plasterboard, see fig. 9.
Install the upper part of the hood in the plasterbo
ard niche already made, the 4 holes must coinci
de with the threaded bars previously installed, as
shown in fig. 10.
Bring the product to the stop of the washers pre
viously positioned.
Secure the product with the 4 washers and 4 nuts
supplied. (fig. 11)
Connect the air outlet ducting (fig. 12).
Take the frame of the dismantled hood and
position it under the opening made in the
plasterboard(fig.13).