13
Daitem security system
PERFORMING A REAL TEST ON YOUR SECURITY SYSTEM
You are now going to perform a real test on your security system. This test will trigger the alarm units and trans-
mit a message to your remote central station monitoring company or individual correspondents by phone.
We recommend you warn the person(s) in charge of remotely monitoring your system beforehand.
➊
Close all the entrances and leave the protected areas
for at least 90 secs to allow any movement detectors to set.
➋
Switch ON (ARM) the system
• when it receives the ON command, the
control panel responds:
"beep, armed"
➌
Wait until the end of the Exit time delay
• the control panel announces:
“armed”
➍
After 90 secs enter a protected room
• the control panel and siren are triggered,
• the telephone dialler calls the
programmed correspondents depending
on the type of event transmitted.
➎
Let the sirens sound for 30 sec.
and then switch OFF (disarm) the system.
• on receipt of the OFF command, the
sirens stop and the control panel responds:
“Beep, OFF, on 21 5 2005 at 7:30 PM,
intrusion, detector 3, group 1”.
➏
Check the alarm was transmitted by phone
to your programmed correspondents*.
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
(
“Beep, OFF, on 21 5 2005 at 7:30
PM, intrusion, detector 3, group 1”.
"beep, armed"
“armed”
* When the call is to an individual alone, the system OFF command stops the call trans-
mission to the correspondents.