96
When it leaves the factory the universal transmitter has a default configuration for each loop.
If this default configuration is suitable for the application intended for the universal transmitter, programme the loop(s) on the control
panel.
Loop n° 1: technical detector application (using terminal block n° 1)
• type of external sensor: NO (default parameter value = 6),
• detector type: technical sensor (default parameter value = 6),
• no inhibition after each detection: inhibition disabled (default parameter value = 1),
• alarm level: specific to technical detector (see system booklet).
Loop n° 2: ON/OFF (arming/disarming) control (using terminal block n° 2)
• type of external contact: NC bistable command (default parameter value = 5),
• order transmitted when loop activated: Total Armed (default parameter value = 23),
• order transmitted when loop de-activated: Total OFF (default parameter value = 21).
3. Default configuration
IMPORTANT: in all other cases, the loop must first be configured before being programmed on the control panel. In this case refer to the Advanced
configuration operations chapter.
Summary of Contents for 221-21 Series
Page 111: ...111 ...