Run a wire from the LED power supply to the LED
module and connect.
NOTE: Must be used with Class 2 24 Volt Power
Supplies.
NOTE: Refer to Maximum Loading & Remote
Mounting Specifications on page 5.
LED
Power
Supply
To Tetra LED System
Red (+)
Black or blue (-)
To LED
power
supply
Red (+)
Black or
blue (-)
Red Stripe (+)
Connect the red stripe wire (+) of the LED
strip to the red wire (+) of the power supply.
Connect the white wire (-) of the LED strip to the
black or blue wire (-) of the LED power supply.
NOTE: All electrical connections should be
suitably protected from mechanical damage and
the environment. Seal all connections in wet
locations with electrical grade RTV silicone.
White (-)
Seal all connections in wet locations
with electrical grade RTV silicone
3
4
OPTIONAL
A Weather Box (GEXNWB2) may be used
to house and seal Class 2 connections as
described below:
A) Insert wire connectors into weather box. Fill
with electrical grade silicone and close box.
B) Secure the weather box using a #6 or #8
(M2 or M3) screw.
Weather box
can be painted
Light engine
A
B
Electrical Connections
NOTE: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease to seal connections.
Cap wires
Optional: Cut wires flush
Must cap all exposed wires with appropriate wire
connectors and seal with electrical grade RTV
silicone. Optional: Cut wires flush to the module
and seal with electrical grade RTV silicone.
Connect LED strips using in-line (IDC)
connectors or twist-on wire connectors.
NOTE: Seal all connections in wet locations
with electrical grade RTV silicone.
Red stripe (+)
White (-)
Seal all connections in wet locations
with electrical grade RTV silicone
1
2
Tetra
®
Atom
Installation Guide
4
