UltraMax® Connected LED Driver (GED80MCC/Z2P1500)
Installation Guide
2
1. Remove power from LED luminaire by switching circuit breaker powering the LED luminaire to the off position.
CAUTION: Turning off the LED luminaire’s wall switch may not remove voltage from the LED luminaire.
2. For maximum safety, LED luminaire must be grounded. Make sure LED luminaire is properly grounded with a green
ground wire per National Electrical Code (NEC).
3. Verify that the LED driver is the correct LED driver for the LED luminaire, input voltage, and application.
4. Follow all relevant National Electric Code (NEC), Federal, State and Local Electric Codes as well as U.L. safety standards.
5. Access and open driver compartment cover.
6. Remove old driver and any extra wires from enclosure.
7. Inspect and replace any damaged or deteriorated cable.
8. Review the wiring diagram on the new driver label and identify connections to be made.
9. Install the new LED driver and make sure the new LED driver is properly grounded to metal of LED luminaire per
National Electrical Code (NEC). Tighten driver mounting screws seating driver firmly against the LED luminaire
surface. To ensure electrical grounding between driver case and LED luminaire housing, mounting screws with star
washers are recommended to break (penetrate) the painted surface of the driver mounting foot.
10. Install the antenna within the LED luminaire enclosure (away from grounded metal surfaces when possible). The
antenna shall not be cut or have any insulation material removed or tampered with in any way.
11. Use only U.L. approved wire connectors for all electrical connections.
CAUTION: Wire connectors must be securely fastened and must completely cover exposed wire ends to prevent
shock hazard.
12. Be sure to insulate unused leads INDIVIDUALLY to 600Vrms using U.L. approved wire connectors.
13. Verify that all installation and safety requirements have been completed and reinstall driver cover.
14. Restore power at circuit breaker, apply power to the fixture and ensure LED luminaire is operational.
Before installing this driver:
During installation:
After driver installation:
