2
Proline® LEX Series Exit Sign
Installation Guide
Wall Mount Installation
1
Use flat head screwdriver to loosen the screws on the lens.
2
Remove lens from sign, set aside.
3
Remove EXIT stencil from housing, set aside.
4
Drill or knockout appropriate knockouts on back plate to fit junction box (not provided) mounting points.
6
Remove backing from self-adhesive junction box gasket and adhere to back plate.
7
Route fixture input wires through center hole of the back plate and make wiring connection. For 120V,
use black and white wires and for 227V use red and white wires. Properly insulate the unused lead with
a wire nut (provided) or other approved means.
8
Secure back plate to junction box. (Not included)
9
Remove proper chevron(s) from the face plate as required. When removing chevrons it may be helpful
to remove the color diffuser panel to allow easier access to the chevrons. If removing color diffuser panel
it is important to remember to reinstall the diffuser panel once chevron(s) have been removed.
10
Connect battery to lamp board (battery back-up models only).
11
Secure face plate to the housing.
12
Secure lens to fixture and securely torque screws.
13
Apply continuous AC power and press TEST button to check operation.
5
Drill or knockout holes in back plate for fixture supply wire leads.
