3
Proline® LEX Series Exit Sign
Installation Guide
Ceiling or End Mount Installation
1
Use flat head screwdriver to loosen the screws on the len(es).
2
Remove lens from sign, set aside.
3
Remove EXIT stencil from housing, set aside.
4
Drill 3/4″ holes through the desired mounting knockouts located on the fixture frame. For ceiling mount,
knockouts will be located on the top of the fixture frame. For end mount, knockouts will be located
on the side of the fixture frame.
5
Using provided hardware, thread nut onto pipe nipple. Slide pipe nipple through canopy hole.
6
Remove backing from self adhesive junction box gasket and adhere to back of mounting plate.
Remove backing from self adhesive pipe thread gasket and adhere to front of mounting canopy.
7
Place screws (provided) in holes on the mounting canopy.
8
Route fixture input wires through knockout in fixture frame, pipe nut and metal mounting plate.
9
Make wiring connection. For 120V, use black and white wires and for 227V, use red and white wires.
Properly insulate the unused lead with a wire nut (provided) or other approved means.
13
Remove proper chevron(s) as required. When removing chevrons it may be helpful to remove the
color diffuser panel to allow easier access to the chevrons. If removing color diffuser panel it is important
to remember to reinstall the diffuser panel once the chevron(s) have been removed.
10
Push wire connections into the junction box (not included). Secure mounting plate to junction box
(hardware not included).
14
Connect battery to lamp board (battery back-up models only).
11
Secure canopy to steel mounting plate with screws installed in step 7.
15
Secure face plate to the housing.
12
Place pipe nipple through the mounting hole of the fixture frame until the gasket is touching the frame.
Thread a second nut onto the pipe nipple on the inside of the fixture frame to lock the canopy into place.
Once canopy is locked into position there will not be any side-to-side movement of the canopy.
16
Secure lens to fixture and securely torque screws.
17
Apply continuous AC power and press TEST button to check operation.
