Daikin VHF, Installation And Maintenance Manual

Page: 7 / 64

r
eCeiving and
s
torage
www.DaikinApplied.com 7 Vertical Stack WSHP • IM 986-11
Handling
Carefully check items against the bills of lading to verify all
crates and cartons have been received.Cabinets and Chassis
normally ship four to a pallet.
Carefully inspect all units for shipping damage. Report
damage immediately to the carrier and file a claim.
Check the unit data plate to be sure the unit electrical agrees
with the power supply available ( Figure 1 ).
DO NOT handle units by the riser piping. Riser clamps hold the
riser in position; they are not designed to support the cabinet
weight. The clamps are removed after the unit is installed.
Figure 1: Unit components & descriptions - received as
assembled cabinet with chassis shipped separate
1
1a
1b
1b
2
3
4
Unit
Data Plate
Stub-out
Seals
Chassis
Data Plate
Component Descriptions (Assembled Cabinet)
1 .
Cabinet assembly complete (without chassis)
1a .
Pipe riser sets (return, supply and condensate)
1b . Inner front panel and filter bracket
2 . Cooling and heating chassis (shipped separate)
3 . Return air grille/panel (accessory)
4 . Double-deflection diffuser (accessory)
Unit cabinets are factory assembled and wired and have
individual thermostat control capability. They are installed by
stacking one unit on top of the other. While installing, prevent
dirt and other foreign matter from entering the risers and plug-
ging lines or valves.
General Information
Daikin Vertical Stack units are designed for use in multiple floor
apartments, office buildings, hotels, nursing homes and other
similar applications. They require a minimum amount of floor
space and are designed for multiple discharge arrangement.
Installation and maintenance must follow accepted industry
practices as described in the ASHRAE Handbook, the National
Electric Code, and other applicable standards. Install this
equipment in accordance with regulations of authorities having
jurisdiction and with all applicable codes.
CAUTION
Sharp metal edges are a hazard, use care when servicing
to avoid contact with them.
WARNING
The installer must determine and follow all applicable
codes and regulations. This equipment presents hazards
of electricity, rotating parts, sharp edges, heat and weight.
Failure to read and follow these instructions can result in
property damage, severe personal injury or death. This
equipment must be installed by experienced, trained
personnel only.
CAUTION
Installation and maintenance are to be performed by
qualified personnel who are familiar with local codes and
regulations, and experienced with this type of equipment.