Daikin RKN09KEVJU, Operation Manual

Page: 86 / 178

EDUS041111_a Installation Manual
Room Air Conditioners K-Series 85
Purging air and checking gas leakage
5.
When piping work is completed, it is necessary to purge the air and check for gas leakage. •
WARNING
Do not mix any substance other than the specifi •
When refrigerant gas leaks occur, ventilate the room as soon and as much as possible. •
R410A, as well as other refrigerants, should always be recovered and never be released directly into the environment. •
Use a vacuum pump for R410A exclusively. Using the same vacuum pump for di fferent refrigerants may damage the vacuum •
pump or the unit.
• If using additional refrigerant, perform air purging from the refrigerant pipes
and indoor unit using a vacuum pump, then charge additional refrigerant.
Use a hexagonal wrench (3/16 inch (4mm)) to operate the stop valve rod.
•
All refrigerant pipe joints should be tightened with a torque wrench at the •
specifi
Connect projection side of charging hose (which comes from gauge manifold) to gas stop valve’s service port. 1)
Fully open gauge manifold’s low-pressure valve (Lo) and completely close its high-pressure valve (Hi). 2)
(High-pressure valve subsequently requires no operation.)
Do vacuum pumping and make sure that the compound pressure gauge reads –29.9inHg (–0.1MPa).*1 3)
Close gauge manifold’s low-pressure valve (Lo) and stop vacuum pump. 4)
(Keep this state for a few minutes to make sure that the compound pressure gauge pointer does not swing back.)*2
Remove caps from liquid stop valve and gas stop valve. 5)
Turn the liquid stop valve’s rod 90 degrees counterclockwise with a hexagonal wrench to open valve. 6)
Close it after 5 seconds, and check for gas leakage.
Using soapy water, check for gas leakage from indoor unit’s fl
are and valve rods.
After the check is complete, wipe all soapy water off.
Disconnect charging hose from gas stop valve’s service port, then fully open liquid and gas stop valves. 7)
(Do not attempt to turn valve rod beyond its stop.)
Tighten valve caps and service port caps for the liquid and gas stop valves with a torque wrench at the specified torques. 8)
*1. Pipe length vs. vacuum pump run time
Pipe length Up to 49.2ft (15m) More than 49.2ft (15m)
Run time Not less than 10 min. Not less than 15 min
*2. If the compound pressure gauge pointer swings back, refrigerant may have water content or a loose pipe joint may exists.
Check all pipe joints and retighten nuts as needed, then repeat steps 2) through 4).
Gauge
manifold
Compound
pressure gauge
Pressure meter
Low-pressure
valve
High-pressure
valve
Charging
hoses
Vacuum pump
Valve caps
Service port
Liquid
stop
valve
Gas
stop
valve
ed refrigerant (R410A) into the refrigeration cycle.
ed tightening torque.
are and outdoor unit’s fl