5
ON/OFF BUTTON
NON FUNCTIONING DISPLAY
Press the button to start or stop the air conditioner.
OPERATION INDICATOR
This indicator illuminates (RED) when the air
conditioner is operating.
CENTRALISED CONTROL INDICATOR " "
TIMER MODE START / STOP BUTTON
This symbol indicates that the air conditioner is
under control from an optional centralised control
panel.
Press this button to select the setting for timer stop.
Press the button a second time to select the setting
for timer start.
HEAT RECLAIM VENTILATION / AIR CLEANING
" " " " " " " "
PROGRAM TIMER ON / OFF BUTTON
This symbol indicates that the optional Heat Reclaim
Ventilation Unit is operating. (for commercial use).
Press this button after entering the desired off/on
time to initiate the timer function.
OPERATION DISPLAY
" " " " " " " " " "
Fan Dry Auto Cool Heat
INSPECTION / TEST OPERATION BUTTON
This display shows the current OPERATION MODE.
For cooling only type, " " (Auto) and " "
(Heating) are not selectable.
This button is for use by installation or service
technicians only.
INSPECTION / TEST INDICATOR " "
PROGRAM TIME BUTTON
This symbol flashes to indicate that TEST /
INSPECTION BUTTON has been pressed or that the
microprocessor has determined that a fault condition
has occurred.
Push on the up arrow to increase the desired
program stop / start time. Push on the down arrow to
decrease the desired program stop / start time.
PROGRAM TIME INDICATOR " "
TEMPERATURE SET BUTTON
These symbols and numbers indicate the
programmed stop (off) and start (on) time.
Push on the up arrow to increase the desired room
temperature. Push on the down arrow to decrease
the desired room temperature.
SELECTED TEMPERATURE DISPLAY " "
FILTER CLEAN RESET BUTTON
This display indicates the desired room temperature.
Press this button to reset the CLEAN FILTER
INDICATOR after you have inspected / cleaned the
indoor return air filter.
FAN SPEED DISPLAY " "
FAN SPEED SELECTOR BUTTON
This display indicates the selected fan speed (ie.
high or low).
Press this button to toggle between high and low fan
speed.
FILTER CLEAN INDICATOR " "
OPERATION MODE SELECTOR BUTTON
This symbol indicates that the indoor return air filter
may require cleaning.
Press this button to change the desired mode of
operation. (ie. fan, program dry, auto, cool, heat).
DEFROST INDICATOR " "
This symbol indicates that the air conditioner is in the
process of removing the build up of ice on the
outdoor unit. (Heat Pump model only).
11
NOTE:
!
For the sake of explanation, all indications are shown on
the display in Fig. 1 contrary to actual running situation.
9
19
10
20
7
17
8
18
5
15
6
16
3
13
4
14
FUNCTIONS OF THE REMOTE CONTROLLER
All controls except for the ON / OFF BUTTON are located behind a swing door on the bottom half of the remote
controller. To access these controls simply open the door by gently pulling down on the finger grip located on the top
right hand edge of the door. To close the door simply swing it back up until it clicks into the closed position.
Once the desire temperature, fan speed and mode of operation have been set there is no need to access the controls
behind the door. Basic operation of the air conditioner is simply a matter of pressing the ON / OFF BUTTON.
Please note that the selected temperature, fan speed and mode of operation will always be displayed even when the air
conditioner is not operating.
1
2
If a particular function is not available, pressing the
button may display the words "NOT AVAILABLE" for
a few seconds. When running multiple units
simultaneously the "NOT AVAILABLE" message will
only appear if none of the indoor units is equipped
with the function. Even if one unit is equipped, the
display will not appear.
12
TEST
hr
hr
C
