23
Advanced Settings
Advanced Settings
FAN lamps (Low, Standard, Turbo)
Dust/PM2.5 Sensor Sensitivity Setting
When the sensitivity of the dust/PM2.5 sensor does not meet your preferences
The sensitivity setting of the dust/PM2.5 sensor can be changed. (Setting at time of purchase: Normal)
1.
Hold down
for about 5 seconds and when a short beep sounds, press
while pressing
.
(Setting can be performed either during operation or while operation is stopped.)
2.
When a short beep sounds, release
and
.
• One of the FAN lamps “ (Low)/ (Standard)/
(Turbo)” will blink for about 5 seconds and then the lamp corresponding
to the currently set sensitivity will light up.
3.
Press
to change the sensitivity setting.
• Each press cycles between the FAN lamps allowing you to change the sensitivity.
To set sensitivity
High
Select the FAN lamp
(Turbo).
(Turbo)
(Standard)
(Low)
High
Normal
Low
The sensor is
highly receptive.
The sensor is
slightly receptive.
Setting at time
of purchase.
To set sensitivity
Low
Select the FAN lamp (Low).
• Setting is indicated using the FAN lamps. If the FAN lamps do not change, unplug the unit, wait at least 5 seconds, then
re-insert the power supply plug and repeat the above procedure from the beginning.
4.
Press
after selecting the new setting.
• A short beep sounds and the new setting will blink.
5.
While the lamp is blinking, unplug the power supply plug, wait at least 5 seconds, and then insert the
power supply plug again. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
Settings are remembered even if the unit is unplugged.
Operating panel
