25
Troubleshooting
Before consulting your dealer or asking for repairs, check the following points.
If the problems still can not be solved, consult your dealer.
The lamp lights up or blinks.
■
The airflow rate lamps blink
simultaneously.
■
The unit does not blow air.
●
Is there any obstacle in the air outlet?
Disconnect the power plug and remove the obstacle. Reconnect
the power plug and turn the power on.
If the present condition does not change or you can not remove
the obstacle, consult your dealer.
The “UNIT1” lamp or “UNIT2”
lamp does not go off or light
up again even after cleaning
UNIT1 or UNIT2.
●
Are UNIT1 and UNIT2 set correctly?
Insert UNIT1 until it clicks.
Insert UNIT2 completely to the end.
►
Page 17-20.
●
Are water drops, detergent, or bits of fibre left in UNIT1 and
UNIT2 after cleaning?
After cleaning, wash UNIT1 and UNIT2 well so as not to leave
detergent or bits of fibre, and completely dry them.
●
Are the ionised wires cut?
Check the ionised wires. Consult your dealer for replacement with
new ones.
The filter lamp does not go off,
although the pleated filter is
replaced.
●
Did you press the filter reset button for 5 seconds?
Even if the pleated filter is replaced, unless you press the filter
reset button for 5 seconds, the filter lamp does not go off.
►
Page 21.
Other
There is a burn mark on the
metal part of UNIT2.
●
This is a mark made by the streamer discharge and is not abnormal.
The TV picture is distorted.
●
Is a TV or radio installed within 2m of the unit or is an indoor
antenna used close to the unit?
●
Is the power supply cord or the antenna of the TV or radio close
to the unit?
Move the unit as far away from TVs, radios and antennas as
possible.
Just inserting the power plug
causes operation to start.
●
Did you disconnect the power plug during a power failure to
move the unit or disconnect the power plug during the last
operation?
The auto-restart function automatically resumes operation.
A sound is heard.
A crackling or buzzing sound
is heard during operation.
●
Are UNIT1 and UNIT2 correctly set?
Insert UNIT1 until it clicks.
Insert UNIT2 completely to the end.
►
Page 17-20.
●
Is dust adhered to UNIT1 and UNIT2?
►
Page 19, 20.
A fizzing sound is heard
during operation.
●
UNIT2 makes a hissing sound caused by the streamer discharge
during operation.
Depending on the usage conditions, the sound becomes lower or the
sound quality may change, but this does not indicate any problem
with operation.
If the sound persists, change the installation site of the unit.
01_EN_3P276413-4F.indd 25
8/1/2012 11:30:01 AM
