15
Maintenance
WARNING
Before cleaning and maintenance work, make sure to
unplug the unit. (An electric shock or injury may result)
Maintenance
Replacing the Streamer Unit
If the streamer lamp blinks
The streamer unit will not need to be replaced. However, depending on where the unit is used
(places where oils are present, or dust and humidity is abundant, or sprays and chemical agents
are used, etc.) replacement may become necessary.
►
Page 17
Contact the place of purchase.
1.
Remove the pre-fi lter on the left side from the
back of the unit.
►
Page 13
2.
Flip up the protective covers and remove the
streamer unit cover.
Streamer unit cover
Viewed from rear
Place your fi nger on the hook
and pull it towards you.
Protective
covers
Hook
3.
Remove the streamer unit.
1
Remove the streamer unit connector.
1. Push the hook on the connector
2.
Pull it out while pushing the hook
The lock will not release unless
the hook is pushed
(Pulling forcibly may cause damage)
2
1
Connector
Hook
2
Push in the left side of the streamer unit so the right
side comes out.
You will hear a
catching sound.
3
Remove the streamer unit.
4.
Attach the new streamer unit.
1 Insert the streamer unit from the left side, and push
until the hook makes a catching sound.
Catching sound
2 Make sure the hook is facing to the right, and insert
the connector as deeply as it will go.
5.
Attach the streamer unit cover.
Push until you
hear a catching
sound
Secure the hooks (2 locations)
on the left side of the streamer
unit cover
Hook
•
Ensure you don’t trap the connector cord.
•
If the streamer unit cover is not properly attached the
safety switch will engage, and the unit cannot operate.
6.
Attach the pre-fi lter.
►
Page 13
7.
Insert the power supply plug while pressing
on the unit, and wait until a short beep
sounds.
• The streamer lamp will turn off.
•
If you release
and attempt operation before the
short beep sounds, the streamer lamp will blink again.
•
If you perform this step and the streamer lamp still blinks,
please check that the connector is properly inserted.
01_EN_3P484757-1D.indd 15
10/1/2018 11:37:17 AM
